PRIMARY PURPOSE:

Under general supervision, maintain the flow and drainage of water, air, and other gases by assembling, installing, and repairing pipes, fittings, and plumbing fixtures districtwide. Maintain and provide for the safe condition and operation of all plumbing systems in district facilities.

QUALIFICATIONS:

Education/Certification

High school diploma or GED

Valid journeyman plumber’s license issued by the Texas State Board of Plumbing Examiners

Clear and valid Texas driver’s license

Special Knowledge/Skills

Knowledge of plumbing repairs, maintenance, and installation techniques

Knowledge of plumbing codes

Ability to read and interpret blueprints, diagrams, schematics, and written reference material

Ability to follow written and verbal instructions

Ability to perform mathematical calculations

Ability to diagnose and resolve problems

MAJOR RESPONSIBILITIES AND DUTIES:

Maintenance and Repair

1. Assemble, install, maintain, and pressure test all pipes, fittings, and fixtures of heating, water,     drainage, sprinkler, and gas systems according to specifications and plumbing codes.
2. Detect needed repairs on buildings, grounds, and equipment following established inspection procedures. Determine sources of plumbing malfunctions and complete repairs as indicated or according to work orders.
3. Install and repair pipes, fittings, valves, fixtures, and plumbing system equipment including sinks, commodes, and water heaters. Install and repair kitchen equipment such as gas stoves and dishwashers.
4. Receive and complete work orders. Select material and hardware and make time and materials estimates. Maintain accurate records on material and labor used.
5. Inspect jobs upon completion and ensure areas are clean.
6. Work with building principals and supervisors to complete projects.
7. Respond to emergency calls as needed.

Safety

8. Maintain inventory of district-owned tools, equipment, and materials. Perform preventive maintenance on tools and equipment and ensure equipment is in safe operating condition.
9. Follow established safety procedures and techniques to perform job duties including lifting and climbing. Operate tools and equipment according to established safety procedures.
10. Correct unsafe conditions in work area and promptly report any conditions that are not immediately correctable to supervisor.
11. Follow district safety protocols and emergency procedures.
12.   Must attend and participate in all safety meetings.

Other

13. Attendance is an essential job function
14. Other duties as assigned.

SUPERVISORY RESPONSIBILITIES:

None

EQUIPMENT USED:  (Not limited to the following)

Plumbing tools and equipment including pipe bender, propane torch; hand tools; power tools; heavy equipment including forklift, trencher, backhoe; light truck or van

WORKING CONDITIONS:

Mental Demands/Physical Demands/Environmental Factors

Frequent walking, climbing stairs/ladders/scaffolding, grasping/squeezing, wrist flexion/extension, and overhead reaching; frequent driving, heavy lifting and carrying (45 pounds and over) on a daily basis, work outside and inside, on slippery or uneven walking surfaces; frequent exposure to extreme hot and cold temperatures, dust, toxic chemicals and fumes, noise, vibration, and electrical hazards; work around gas lines; work around machinery with moving parts; may work in tight or enclosed spaces; may work alone; regularly work irregular hours; occasional prolonged hours; frequent districtwide travel, maintain emotional control under stress